Replacing The Shaving Heads - Philips AT815 User Manual

ENGLISH
22
C
7 Clean the inside and outside of the comb
with the brush supplied.
For optimum performance, shaver cutters and
combs should be cleaned in a degreasing liquid
(e.g. alcohol) and lubricated with one drop of
mineral oil (in the center of the head). This helps
prevent wear of the shaving heads.
C
8 Replace the set back into the Shaver Head
Assembly.
Make sure that the two pointy edges of the
head fit exactly into the recesses.
9 Repeat the process for the other two sets
of cutters and combs.
10 Replace the frame and turn the lock
clockwise until it locks into place.
C
11 Insert the notch of the shaving unit into
the slot in the top of the shaver (1) and
1
then close the shaving unit (2).
2
NOTE: If the shaving unit does not close smoothly,
make sure you inserted the shaving heads
properly and that the retaining frame is locked.
12 Put the Protective Cap on shaver to
protect heads.
After Each Use: Trimmer
1 Turn shaver OFF.
C
2 Push down spring-release trimmer switch.
C
3 Clean trimmer with the short-bristled side
of the brush every time you use it. Brush
up and down along the trimmer teeth.
C
4 Lubricate the trimmer teeth with one
drop of mineral oil every 6 months.
5 Close trimmer by pressing trimmer down.

Replacing the Shaving Heads

Q Replace the shaving heads once a year for
optimal shaving results.
Q Replace damaged or worn shaver heads with
model HQ8 Philips Norelco shaving heads
only.
ENGLISH
23