Anynet+ (Hdmi-Cec) - Samsung UN32F5500AH E-Manual

Anynet+ (HDMI-CEC)

There is something wrong
with the TV.
Anynet+ does not work.
I want to start Anynet+.
I want to exit Anynet+.
The message
"Connecting to
Anynet+ device..." or
"Disconnecting from
Anynet+ device" appears
on the screen.
The Anynet+ device
won't play.
The connected device is
not displayed.
The TV audio is not
being played through
the receiver.
Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+
devices only.
Only one external device may be connected to Receiver.
Check if the power cord of the Anynet+ device is properly connected.
Check the cable connections of the Anynet+ device.
Navigate to the System
Check whether the TV remote control is in TV mode.
Check whether the remote control is Anynet+ compatible.
Anynet+ may not function under certain circumstances. (Searching channels,
operating Smart Hub or Setup, etc.)
If you have disconnected and then reconnected the HDMI cable, scan for devices
again or turn your TV off and on.
Check if the Anynet+ device is properly connected to the TV and then navigate to
the System menu to see if
After checking, select the Virtual Remote panel's or the regular remote's
buttonn to display the list. Select
Select View TV from the Anynet+ menu.
Select a non-Anynet+ device from Source.
You cannot use the remote control when you are configuring Anynet+ or
switching to a viewing mode. Use the remote control after the TV has completed
the Anynet+ configuration or has switched to a viewing mode.
You cannot use the play function when
Check whether the device supports Anynet+.
Check whether the HDMI cable is properly connected.
Navigate to the System
Scan for Anynet+ devices again.
Anynet+ devices must be connected to the TV using an HDMI cable. Make sure
the device is connected to your TV with an HDMI cable. Some HDMI cables may
not support Anynet+.
If the connection is terminated because there has been a power failure or the
HDMI cable has been disconnected, please scan for the device again.
Connect an optical cable to the TV and the receiver.
ARC enables digital sound to be output via the HDMI (ARC) port.
However, ARC is only available when the TV is connected to an audio receiver
that supports ARC.
Try this!
menu and verify that Anynet+ (HDMI-CEC)
Anynet+ (HDMI-CEC)
Anynet+ (HDMI-CEC)
Setup is progress.
menu and verify that Anynet+ (HDMI-CEC)
is set to On.
is set to On.
from the list.
is set to On.
TOOLS