Acorp 4845PE Manual page 48

Chapter 2
UART Mode Select
This item allows you to select which Infra Red(IR) function of
the onboard I/O chip you wish to use.
The Choices: Normal(default), IrDA, SCR, ASKIR.
UR2 Duplex Mode
This item allows you to select which Infra Red(IR) function of
the onboard I/O chip you wish to use.
The Choices: Half (default), Full.
Onboard Parallel Port
This item allows you to select the onboard parallel port and IRQ.
The Choices: 378/IRQ7; 278/IRQ5; 3BC/IRQ7; Disabled
Parallel Port Mode
The choices are for Parallel Port Mode select:
SPP: Using Parallel port as Standard Parallel Port.
EPP: Using Parallel port as Enhanced Parallel Port.
ECP (default): Using Parallel port as ExtendedCapabilites Port.
ECP+EPP: Using Parallel port as ECP+EPP mode.
ECP Mode Use DMA
The Choices: 3(default), 1.
PWRON After PWR-Fail
Set the Power-on mode when power resumes after power fails.:
The choices: Off (default); On; Former-Sts (former status)
Game Port Address
The choices are for setting Game Port Address:
201 (default); 209; Disabled
MIDI Port Address
The choices are for setting MIDI Port Address:
300; 330 (default); Disabled.
MIDI Port IRQ
The choices are for setting MIDI Port IRQ:
10 (default): 5
4845PE BIOS Setup
2-48