Angle Designment; Zeith Measurement - SMART MAX GEOSYSTEMS DE2A Manual

SMART MAX GEOSYSTEMS CO.,LTD
www.smartmaxgeosystems.com
Laser Orientation Measurement.
Steps as bellows：
1.Leveling the instrument, then power on.
2.Aim at the target through the horizontal Tangent & Clamp
Screws.Turn on the laser.The other points can be found out with a
board which can make the laser focus together.

7.2 Angle Designment

Angle Designment is based on the line of two points,then
design a horizontal angle according with the requirement.
Steps as bellows：
1.Leveling the instrument, then power on.This must be done on a
fiducial point.
2.Aim at another fiducial point carefully,and set the horizontal
0°00'00".
angle as
3.Move the telescope to make the horizontal angle be the required
value.Turn the laser on,the laser and the fiducial line will make
up an angle.

7.3 Zeith Measurement

Set a point as a standard, the laser will be set up vertically,this is
Zeith Measurement.
Steps as bellows：
info@smartmaxgeosystems.com
22