Table of Contents
Advertisement
CPU ADAM 821x
Project
engineering
CPU 821x with
central periphery
Master projecting
of the CPU
821xDPM
ADAM 8000 Manual CPU 821x – Rev 1.1
The following steps are necessary to project a CPU 821x in the hardware
configurator from Siemens:
• Start the hardware configurator from Siemens
• Load the delivered ADAM GSD-file from Advantech
• Create a Profibus-DP master system with the CPU 315-2DP
• Include the slave system "ADAM_DP8000" from the hardware catalog in
your master system. You find this slave system in the hardware catalog
under Profibus-DP > Additional field devices > I/O > ADAM
• Assign the address 1 to your slave system, so that the CPU is able to
recognize the system as central periphery system
• Add your modules to the slave system in the same order you have
assembled them. Start with the CPU at plug-in location 0
• Include your System 82xx modules starting at plug-in location 1
CPU 821x
PB-
Adr.:2
When projecting a CPU 821xDPM you include the central modules like
described above. Slave systems that shall be connected to the master are
added to the already existing master system:
CPU 821xDPM central
PB-
Add.:2
DP200V
PB-
Adr.:1
Slot
Module
0
821x-xxxx
1
.
Expansion
.
modules
.
3
DP slaves decentral ...
PB-
DP200V
ADAM 821x
Add.:1
Slot
Module
0
821x-2BM01
1
.
central
.
periphery
.
32
Chapter 1 Principles
DP200V
PB-
ADAM821xDP
Adr.:3 ... 125
1-9
Advertisement
Table of Contents
