Adam 821x Manual page 101

Chapter 4 Deployment of the CPU 821xNET
Receive tab
1
2
4-38
In this dialog window you configure the reception of messages from a
specific host.
Input fields
Remote Host IP address of the station where the data will be saved.
Remote Port Port address of the remote station.
Local Port Port address of own (local) station. To simplify matters
you may specify the same port address for remote and
local.
Tick-box
UDP This tick mark selects unsecured communications. No
virtual connections are used by unsecured communication
links. In this manner you may only display UDP
messages.
AutoListen If you select "AutoListen", the program switches to receive
mode. Every message received from the remote CP is
displayed in the list. Interruptions of the connection are
detected and displayed, however, the program remains
ready to receive data. As soon as the connection is re-
established messages will again be listed.
Buttons
Listen Any received messages are entered into the list. The
listing is stopped when you click the "STOP" button or the
connection is interrupted. You may also stop the listing by
entering a new set of connection parameters.
ClearList Clears the received list, new entries will appear at the top
of the list.
[1] Connection data
[2] connection status
3
information bar
4
[3] clear received list
[4] list messages
[5] list of received messages
5
ADAM 8000 Manual CPU 821x – Rev 1.1
CPU ADAM 821x