Initial Camera Setup - Vivitar DVR 910HD User Manual

Initial Camera Setup

Flip open the LCD screen. When powering the camera ON for the first time the camera will take you
through the initial camera setup.
Powering the Camera ON
1) Installing the Batteries
Make sure the batteries have been inserted properly into your digital camera, according to the
polarity shown inside the battery compartment.
Use 4 x AAA (1.5v) batteries. Alkaline batteries are recommended. (Batteries not included.)
Note:

Remove the batteries from the camera when not in use for an extended period.

Do not mix alkaline and non-alkaline batteries.

Some camera features (Flash) will not work if the battery power level is low.

When the battery power is low the battery icon turns red and the camera will automatically
turn off a few seconds later.

The energy status of the power is displayed on LCD as shown below:
Full battery power Medium battery power
6
Low battery power