Replacing The Lcd Panel Module-None Touch - Lenovo 510S Hardware Maintenance Manual

p. Reattach the stand base.

Replacing the LCD panel module-None Touch

Note: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the cover.
Note: It may be helpful to place the computer face-down on a soft flat surface for this procedure. Lenovo
recommends that you use a blanket, towel, or other soft cloth to protect the computer screen from scratches
or other damage.
To replace the LCD panel module:
Step 1. Remove any media from the drives, shut down the operating system, and turn off the computer
and all attached devices.
Step 2. Unplug all power cords from electrical outlets.
Step 3. Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to Locating connectors,
controls and components to locate the various connectors.
Step 4. Remove the stand base. Refer to Removing the stand base.
Step 5. Remove the rear cover. Refer to Removing the rear cover.
Step 6. Remove the stand holder. Refer to Removing the stand holder.
Step 7. Remove the EMI cover. Refer to Removing the EMI cover.
Step 8. Remove the power switch board. Refer to Replacing the power switch board.
Step 9. Remove the system fan. Refer to Replacing the system fan.
Step 10. Remove the motherboard. Refer to Replacing the motherboard.
Step 11. Remove the wind shielding. Refer to Removing the wind shielding.
Step 12. Remove the solid state drive. Refer to Replacing the solid state drive.
Step 13. Remove the speaker system. Refer to Replacing the speaker system.
Step 14. Remove the pull down assembly. Refer to Removing the pull down assembly.
.
Chapter 8 Replacing hardware
53