Removing The Emi Cover - Lenovo 510S Hardware Maintenance Manual

Step 10. To install the new solid state drive:
a. Align the holes in the new solid state drive with the corresponding holes in the storage
converter.
b. Secure the new solid state drive to the converter with four screws.
c. Reinstall the storage converter.
d. Connect the signal cable to the solid state drive.
Step 11. Reattach the stand holder, rear cover, and stand base.

Removing the EMI cover

Note: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the cover.
Note: It may be helpful to place the computer face-down on a soft flat surface for this procedure. Lenovo
recommends that you use a blanket, towel, or other soft cloth to protect the computer screen from scratches
or other damage.
To replace the EMI cover
Step 1. Remove any media from the drives, shut down the operating system, and turn off the computer
and all attached devices.
Step 2. Unplug all power cords from electrical outlets.
Step 3. Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to Locating connectors,
controls and components to locate the various connectors.
Step 4. Remove the stand base. Refer to Removing the stand base.
Step 5. Remove the rear cover. Refer to Removing the rear cover.
Step 6. Remove the stand holder. Refer to Removing the stand holder.
Step 7. Remove the five screws that secure the EMI cover to the chassis, and then lift it up.
Step 8. To install the EMI cover:
34
ideacentre All-In-One 510S Computer Hardware Maintenance Manual