Table of Contents
Advertisement
When installing:
• Correctly route and secure the antenna cables, LCD cable, and camera/LED cable through the cable
guides on the keyboard bezel assembly. Fix the camera/LED cable to the system board with a tape.
Ensure that the cables are not pinched by any components.
• Ensure to install the rubber
1160 Keyboard assembly
To remove the keyboard assembly, remove these FRUs in order:
• "1010 Base cover assembly" on page 63
• "1020 M.2 solid-state drive" on page 64
• "1030 Wireless-LAN card" on page 65
• "1040 Memory module" on page 66
• "1050 Built-in battery" on page 67
• "1060 Thermal fan assembly" on page 69
• "1070 Speaker assembly" on page 71
• "1080 Coin-cell battery" on page 72
• "1090 Trackpad assembly" on page 73
• "1100 Smart card cable and smart card reader" on page 74
• "1110 dc-in bracket and dc-in cable" on page 75
• "1120 Keyboard subcard and keyboard-subcard cable" on page 75
• "1130 System board assembly and side USB connectors" on page 77
• "1140 Fingerprint reader assembly and fingerprint reader bracket" on page 80
• "1150 LCD unit" on page 81
Removing an LCD FRU for models without a touch panel
This section provides instructions on how to remove an LCD FRU for models without a touch panel.
2010 LCD-bezel frame, strip cover, and ThinkShutter
For access, remove these FRUs in order:
• "1010 Base cover assembly" on page 63
• "1150 LCD unit" on page 81
84
P1/X1 ExtremeHardware Maintenance Manual
1
for cable routing.
Advertisement
Table of Contents
