Siemens EUROSET 5015 Quick Manual page 12

Adjusting the loudspeaker
While in handsfree mode, you can set the volume to one of
7 levels and save it (default setting: 7).
H I
... Adjust the volume with the Loud/Quiet key.
Activating/deactivating open listening
The built-in loudspeaker means anyone in the room can lis-
ten-in on a call.
L
During a call:
press the Loudspeaker key.
To deactivate open listening: press the key
again.
When the loudspeaker is activated and the handset is
lifted, open listening is activated. The handsfree micro-
phone is switched off.
When the loudspeaker is activated and the handset is
replaced, handsfree talking via the handsfree microphone
is activated.
Activating/deactivating handsfree mode
With this telephone you can also make calls without lifting
the handset. The optimum distance for speaking into the
microphone is around 50 cm.
◆
Activating via the handset during a call:
L a
+ Replace the handset while pressing the Loud-
speaker key.
◆
Activating before dialling a phone number
L
Before you dial: press and hold the Loud-
speaker key until the dialling tone is audible.
Deactivating handsfree mode:
c
Lift the handset during a call.
Activating/deactivating the mute melody
You can activate and deactivate the mute melody for the
mute (default setting: on).
c?19#
Lift handset, initiate function.
0 1
/ 0: deactivate; 1: activate.
?a
Press the Set key. Replace handset.
4
GB
Baby call (direct call) number setting
If a phone number is set for the Baby Call function, it is
dialled automatically when the telephone is locked after
you lift the handset (or press the Loudspeaker key) and
press any key (except
telephone does not allow other phone numbers to be
dialled, but incoming calls can be received.
c?M8
Lift handset, initiate function.
o
Enter the PIN (default setting: 0000).
Activating
o
Enter direct call number (max. 32 digits; not
<
for pause function!).
or ...
Deleting
;
Press the Last number redial key.
?a
Press the Set key. Replace handset.
Locking/unlocking the telephone
Only the Baby call number can be dialed when the tele-
phone is locked.
c?M
Lift handset, then start the function.
1 2
or 0: unlock; 1: lock
o
Enter the PIN (default setting: 0000).
?a Press the Set key. Replace handset.
If the telephone is locked, the display shows zzzz .
Temporarily deactivating the telephone lock (for one call)
cMo
Lift the handset, press the lock key, enter the
PIN (default setting: 0000).
o
Dial a call number.
The telephone lock is active again when the handset is
replaced.
Locking/unlocking repertory numbers so they cannot
be changed
c?M6
Lift handset, initiate function.
(If necessary, press
the repertory key on the 2nd level.)
o Enter the PIN (default setting: 0000).
0 1
/ 0: Repertory keys not locked
1: Repertory keys locked.
?a
Press the Set key. Replace the handset.
? M L H I
, , , and
=
in order to lock/unlock
). The