Available Accessories; Assembly And Mounting - Jet 709060 Owner's Manual

12" Master Dovetail Jig
Width Capacity .....................................................................................................................................12"
Thickness Capacity.................................................................................................................1/2" – 1-1/4"
Jig Dimensions ........................................................................................................11"W x 17"L x 6-3/4"H
Gross Weight...................................................................................................................................23 lbs.

Available Accessories

709061 ................................................................................................ 5/16" Aluminum Dovetail Template
709062 ................................................................................................ 7/16" Aluminum Dovetail Template
709063 .................................................................................................. 1/2" Aluminum Dovetail Template
709064 ................................................................................................ 9/16" Aluminum Dovetail Template
709239 .......................................................................6 Piece General Purpose Router Bit Set 1/4" Shank
709240 .......................................................................6 Piece General Purpose Router Bit Set 1/2" Shank
709241 .....................................................................10 Piece General Purpose Router Bit Set 1/4" Shank
709242 .....................................................................10 Piece General Purpose Router Bit Set 1/2" Shank
709243 .....................................................................15 Piece General Purpose Router Bit Set 1/4" Shank
709244 .....................................................................15 Piece General Purpose Router Bit Set 1/2" Shank

Assembly and Mounting

1. Thread the rear handle (A, Fig. 1) into the
clamping rod (B, Fig. 1). The rear handle
should be mounted with the cams (C, Fig. 1)
pointing up, as shown in the photo. This
way you will push the handle away from you
to lock the workpiece in the jig.
2. Thread the front handle (D, Fig. 1) into the
clamping rod (E, Fig. 1). The front handle
should be mounted with the cams (F, Fig. 1)
pointing out, as shown in the photo. This
way you will push the handle down from you
to lock the workpiece in the jig.
3. You can mount the jig to a workbench
through the two mounting holes found at the
rear of the jig. You can also mount the jig to
a piece of plywood so that it can be clamped
to your workbench when needed.
4
709060