Location And Function Of Controls - Sony STW-C140X Operating Instructions Manual

Location and Function of Controls

a Antenna (inside)
Avoid covering the antenna.
b POWER button
Press this button to turn on the receiver
box. After turned on, channel and audio
selection is available.
While turned on, press and hold this
button for about two seconds until the
POWER indicator starts blinking in
amber, and press this button once more
to turn off the receiver box.
While turned off and while pressing and
holding the SEL button, press this button
to call up the screen position alignment
check image.
c POWER indicator
Displays the status of the receiver box.
Lit in green: The unit is turned on and
the battery can last more than three
hours.
Lit in amber: The unit is turned on but
the battery may run down in less than
three hours.
Blinks in red five times at power-on:
The battery may have reached its end of
usable life. Contact your Sony sales
10
GB
representative to have the battery
replaced with a new one. The unit may
still work with the old battery, though
the battery may have lost one half its
initial capacity, which means that it may
not last three hours even if the indicator
lights in green.
Blinking: The unit is in the channel or
audio selection mode.
Off: The power of the unit is turned off.
d – button
In Audio mode, press and hold this
button to turn down the volume.
Assistive audio is still audible at the
minimum volume.
e SEL (Select) button
Use this button to set the channel in
"Preparation."
f + button
In Audio mode, press and hold this
button to turn up the volume.
g HI/VI indicator
Indicates the type of audio assistance for
Audio mode.