Basic Operation; Welcome Screen And Good-Bye Screen - Subaru 2016 Legacy Owner's Manual

to "Select lever/gear position indicator"
F3-30.)
Telltale screen (refer to "Telltale screen"
5)
F3-38.)
Odometer (refer to "Odometer" F3-8.)/
6)
double trip meter (refer to "Double trip
meter" F3-9.)
Control switch
1) Up (select)
2) Set (enter)
3) Down (select)
& Basic operation
By operating " " or " " of the control
switch, the screens and selection items
can be switched. When the " /SET"
switch is pulled toward you, the item can
be selected and set.
If there are some useful messages, such
as vehicle information, warning informa-
tion, etc., they will interrupt the current
screen, and appear on the display accom-
panied by a beep. If such a screen is
displayed, take proper action according to
the message shown on the screen.
The warning screen will return to the
original screen after a few seconds. While
the " " information reminder is shown on
the display, it may be possible to display
the warning screen again. To recall the
message marked with " " on the display,
pull the " /SET" switch on the steering
wheel toward you.
& Welcome screen and Good-
bye screen
When the driver's door is opened and
closed after unlocking the door, the
welcome screen will appear on the multi
information display for approximately 20
seconds.
When the ignition switch is turned to the
"LOCK"/"OFF" position, the multi informa-
tion display gradually turns off (Good-bye
screen).
NOTE
. The basic screen will be shown
when the ignition switch is turned to
the "ON" position while the welcome
Instruments and controls/Multi information display
screen is displayed.
. Once the welcome screen appears,
it takes a certain period of time to
display it again.
. If the ignition switch is operated
after unlocking the driver's door, the
welcome screen will not appear even
when the driver's door is opened and
closed.
. The welcome screen will disappear
when you lock the driver's door by
using the remote keyless entry system
(all models) or the keyless access
function (if equipped) while the wel-
come screen is displayed.
. If any of the doors (including the
rear gate) is opened while the welcome
screen is displayed, the door ajar
warning will appear.
. The welcome screen can be set to
on or off. For details, refer to "Welcome
Screen" F3-42.
. The Good-bye screen can be set to
on or off. For details, refer to "Good-
bye Screen" F3-42.
3-35
– CONTINUED –