Subaru 2016 Legacy Owner's Manual page 62

3-62
Instruments and controls/Mirrors
1) HomeLink button 1
®
2) HomeLink button 2
®
3) HomeLink button 3
®
2. Press and hold the two outer
HomeLink buttons (button 1 and button
®
3) until the HomeLink
®
begins to flash (after approximately 10
seconds). Then release both buttons.
3. Hold the end of the entrance gate's/
garage door opener's hand-held transmit-
ter between 1 and 3 inches (25 and 76
mm) away from the HomeLink
wish to program.
4. Press and hold the desired HomeLink
button.
5. Press and release ("cycle") the hand-
held transmitter button every 2 seconds
until step 6 is complete.
6. When the indicator light flashes slowly
and then rapidly after several seconds,
release both buttons.
7. Plug the motor of the entrance gate/
garage door opener to the outlet.
8. Test your entrance gate/garage door
opener by pressing the programmed
HomeLink
! Operating the HomeLink
less Control System
Once programmed, the HomeLink
less Control System can be used to
remote-control the devices to which its
buttons are programmed. To activate a
device, simply press the appropriate but-
ton. The indicator light illuminates, indicat-
ing that the signal is being transmitted.
indicator light
! Programming other devices
To program other devices such as door
locks, home lighting and security systems,
contact HomeLink
or call 1-800-355-3515.
button you
! R e p r o g r a m m i n g a s i n g l e
®
HomeLink
®
1. Press and hold the HomeLink
you wish to reprogram. DO NOT release
the button until step 4 has been com-
pleted.
2. When the HomeLink
button.
®
Wire-
®
Wire-
®
at www.homelink.com
®
button
®
button
®
indicator light
®
begins to flash slowly (after approximately
20 seconds), position the hand-held trans-
mitter of the device between 1 to 3 inches
(25 to 76 mm) away from the HomeLink
button you wish to program.
3. Press and hold the hand-held trans-
mitter button. The HomeLink
light will flash, first slowly and then rapidly.
4. When the indicator light begins to flash
rapidly, release both buttons.
The programming for the previous device
is now erased and the new device can be
operated by pressing the HomeLink
button.
! Erasing HomeLink
®
ory
NOTE
. Performing this procedure erases
the memory of all the preprogrammed
buttons simultaneously. The memory
of individual buttons cannot be erased.
. It is recommended that upon the
sale of the vehicle, the memory of all
programmed HomeLink
®
erased for security purposes.
®
indicator
®
®
button mem-
buttons be