Step 4: Set Up Speed Reference And Start/Stop; Input/Output Configuration Checklists - Allen-Bradley PowerFlex 753 Quick Start Manual

Step 4: Set Up Speed Reference and Start/Stop

Select the configuration according to the wiring you observed in

Input/Output Configuration Checklists

Speed Reference Source
Drive 1 Drive 2 Drive 3
HIM (typically Port 1) (If you have a door-mounted or remote-mounted HIM on Port 2 or Port 3, refer to
Connections on PowerFlex 753 Main Control Board (Port 0)
Connections on 11-Series Expansion I/O Module - Cat. No. 20-750-11xxx-xxxx (Port 4) (See
Connections on 22-Series Expansion I/O Module - Cat. No. 20-750-22xxx-xxxx (Port 4) (See
Communications Connection (See
Start, Stop, and Direction Source
Drive 1 Drive 2 Drive 3
HIM (Port 1)
3-Wire Control (See 2-Wire and 3-Wire Control on page 63
2-Wire Control (See 2-Wire and 3-Wire Control on page 63
Drive 4 Drive 5 Speed Reference Source
User Adjustable at Drive
0...20 mA Analog Input - Unipolar Speed Reference
0...+10V Analog Input - Unipolar Speed Reference
10k Ohm Potentiometer - Unipolar Speed Reference
0...20 mA Analog Input - Unipolar Speed Reference
0...+10V Analog Input - Unipolar Speed Reference
10k Ohm Potentiometer - Unipolar Speed Reference
0...20 mA Analog Input - Unipolar Speed Reference at Terminals Ai0±
0...+10V Analog Input - Unipolar Speed Reference at Terminals Ai0±
10k Ohm Potentiometer - Unipolar Speed Reference at Terminals Ai0±
0...20 mA Analog Input - Unipolar Speed Reference at Terminals Ai1±
0...+10V Analog Input - Unipolar Speed Reference at Terminals Ai1±
10k Ohm Potentiometer - Unipolar Speed Reference at Terminals Ai1±
page 32 for communication option module catalog numbers and port location options.)
Communication over PF755 Embedded Ethernet/IP (Port 13) (Port 13)
Communication over EtherNet/IP on 20-750-ENETR Module (Port 6)
Drive 4 Drive 5 Start, Stop, and Direction Source
User Adjustable at Drive
for more information.)
3-Wire Control on PF753 Main Control Board
3-Wire Control on 11-Series I/O Module
3-Wire Control on 22-Series I/O Module
for more information.)
2-Wire Control on PF753 Main Control Board
2-Wire Control on 11-Series I/O Module
2-Wire Control on 22-Series I/O Module
Rockwell Automation Publication 750-QS001A-EN-P - March 2015
Step 2: Validate the Drive
Drive Device Ports on page 33
page 32 for option module catalog numbers and port location options.)
page 32 for option module catalog numbers and port location options.)
Step 4: Set Up Speed Reference and Start/Stop
Installation.
Wiring Diagram
for more information.)
page 38
page 41
page 42
page 42
page 45
page 45
page 45
page 49
page 49
page 49
page 50
page 50
page 50
page 52
page 57
Wiring Diagram
page 38
page 43
page 47
page 51
page 42
page 46
page 51
17