Allen-Bradley PowerFlex 753 Quick Start Manual page 11

Refer to the diagram on page 10
Item
(1) Are signal sources connected to terminal block TB1 on your PowerFlex 753 drive?
Drive 1: Yes No
(2) Is there a connection to the Embedded EtherNet/IP port on your PowerFlex 755 drive?
Drive 1: Yes No
(3) Are signal sources connected to an expansion I/O module installed in your drive? If yes, note the module's port number.
Drive 1:
Yes: Port No.
(4) Are signal sources connected to a communication network module installed in your PowerFlex 753 drive? If yes, note the module's port number.
Drive 1:
Yes: Port No.
Which EtherNet/IP configuration is your drive using (BOOTP, DHCP, or manual IP address)? If using a manual IP address, enter the IP address and the subnet address.
Drive 1: BOOTP DHCP
Manual
IP Address
Subnet Mask (if required)
Gateway Address (if required)
Verify the status of the enable jumper and the safety jumper.
• If the enable jumper is removed, control power is required at Di0 on the main control board for the drive to be
able to accept a Start command. See parameter 220 [Digital In Sts] bit 0. For more information, see PowerFlex
750-Series AC Drive Installation Instructions, publication 750-IN001.
• If the safety jumper is removed, see Safe Speed Monitor Option Module for PowerFlex 750-Series AC Drives
Safety Reference Manual, publication
Safe-Torque Off User Manual, publication
for item number locations.
Drive 2: Yes No
Drive 2: Yes No
Drive 2:
No Yes: Port No. No
Drive 2:
No Yes: Port No. No
Drive 2: BOOTP DHCP
Manual
IP Address
Subnet Mask (if required)
Gateway Address (if required)
750-RM001
Rockwell Automation Publication 750-QS001A-EN-P - March 2015
Drive 3: Yes No Drive 4:
Drive 3: Yes No Drive 4:
Drive 3: Drive 4:
Yes: Port No. No
Drive 3: Drive 4:
Yes: Port No. No
Drive 3: BOOTP DHCP Drive 4:
Manual
IP Address IP Address
Subnet Mask (if required) Subnet Mask (if required)
Gateway Address (if required) Gateway Address (if required)
for catalog number 20-750-S1 and PowerFlex 750-Series
750-UM002 for catalog number 20-750-S.
Step 2: Validate the Drive Installation
Yes No Drive 5:
Yes No Drive 5:
Drive 5:
Yes: Port No. No Yes: Port No.
Drive 5:
Yes: Port No. No Yes: Port No.
BOOTP DHCP Drive 5:
Manual
IP Address
Subnet Mask (if required)
Gateway Address (if required)
Yes No
Yes No
No
No
BOOTP DHCP
Manual
11