Danfoss TP5001 series Installation Manual page 13

Electronic programmable room thermostat

Hide thumbs Also See for TP5001 series:

Available languages

Option 93 - Set limit sensor set-point, "A" models only,

(option 90 set to 2)

This allows the thermostat limit sensor to be set,

typical application is ﬂ oor htg. Press + until Option

93 is displayed, use V and Λ to select required

setting. If the temperature sensed by the limit

sensor exceeds the limit setting the output will be

turned oﬀ untill the temperature has dropped by

2°C "F10" will ﬂ ash in the display.

Setting

Any value between 20 - 50°C (Factory setting is 27°C)

Option 94 - Conﬁ gure digital input switch type, "A" models only,

(option 90 set to 3)

This allows switch type of digital input to be

conﬁ gured. Press + until Option 94 is displayed, use

V and Λ to select required setting.

Setting 0 Contacts NC, open circuit contact to force unit into

thermostat mode, short circuit contacts to return to normal

operation

Setting 1 Contacts NO, short circuit contacts to force unit into

thermostat mode, open circuit contacts to return to normal

operation (Factory setting)

Show Quick Links