Advertisement
Oven Vent Duct
Your range is vented through a duct
located under the right rear surface
unit. Clean the duct often.
I
To remove:
Make sure unit is cool.
Lift up right rear surface unit.
. Remove drip pan and ring.
Lift out oven vent duct.
To replace:
Place the part over the oven vent
located below the cooktop with
opening of the duct under the round
opening in the drip pan. It is
important that the duct is in the
correct position so moisture and
vapors from the oven can be
released during oven use. NOTE:
Never cover the hole in the oven
vent duct with aluminum foil or
any other material. This prevents
the oven vent from working properly
during any cooking cycle.
Adjusting Oven Thermostat
Use time given on recipe when
cooking first time. Oven thermostats,
in time, may "drift" from the
factory setting and differences in
timing between an old and a new
oven of 5 to 10 minutes are not
unusual. Your oven has been set
correctly at the factory and is more
apt to be accurate than the oven
which it replaced. However, if you
find that your foods consistently
brown too little or too much, you
may make a simple adjustment in
the thermostat (Oven Temp) knob.
PULL KNOB OFF OF SHAFT,
LOOK AT BACK OF KNOB AND
N~E
CURRENT SETTING,
BEFORE MAKING ANY
' ADJUSTMENT.
To increase temperature, turn
toward HI or RAISE; to decrease,
turn toward LO or LOWER. Each
notch changes temperature 10
degrees.
1.
Remove knob, and hold so
Dointer is at toD of knob. Hold
"skirt" of kno~ firmly in one hand.
With other hand, turn knob to move
pointer toward Raise or Lower.
Pointer is designed not to move
easily. If it is seated so it is difficult
to move, pointer maybe loosened
slightly. Insert a thin screwdriver,
knife blade or similar instrument
and lift up end of pointer slightly.
2. After adjustment is made, press
pointer firmly against knob. Return
"bob to range, matching flat area
on knob and shafl. Recheck oven
performance before making an
additional adjustment.
1. Pull off
knob. Loosen both SCEWS
on back of knob.
2. Move pointer one notch in
desired direction. Tighten screws.
3. Return knob to range, matching
flat area of knob to shaft. Recheck
oven performance before making
an additional adjustment.
Lamp Replacement
CAUTION: BEFORE REPLACING
ANY LAMP, DISCONNECT'
ELECTRIC POWER 'IO RANGE
AT THE MAIN FUSE OR CIRCUIT
BREAKER PANEL. LET LAMP
(OR BULB) AND LAMP COVER
COOL COMPLETELY.
21
After replacing lamp (bulb),
reconnect electrical power to
the range.
Oven Lamp
Remove the oven door, if desired,
to reach lamp easily.
If lamp cover is held in place with
three slotted screws...
I
\
Remove the screws, remove
cover, and replace bulb with
40-watt appliance bulb.
Replace lamp cover with three
screws.
If the oven lamp (bulb) has a
removable glass cover which is
held in place with a bail-shaped
wire...
To remove:
Hold hand under cover so it
doesn't fall when released. With
fingers of same hand, firmly push
down wire bail until it clears cover.
Lift off cover, DO N(YT REMOVE
ANY SCREWS TO REMOVE
THIS TYPE OF COVER.
Replace bulb with a 40-watt
home appliance bulb.
To replace cover:
Place cover into groove of lamp
receptacle. Lift wire bail up to
center of cover until it snaps into
place. When in place, wire holds
cover firmly, but be certain wire
bail is not below depression in
center of cover.
Advertisement
