Emerson Rosemount 3051 Reference Manual page 192

®
PROFIBUS Block Information
August 2016
Table D-2. Transducer Block Parameters
Index Parameter name
1 ST_REV
2 TAG_DESC
3 STRATEGY
4 ALERT_KEY
5 TARGET_MODE
6 MODE_BLK
7 ALARM_SUM
8 SENSOR_VALUE
9 SENSOR_HI_LIM
10 SENSOR_LO_LIM
11 CAL_POINT_HI
12 CAL_POINT_LO
13 CAL_MIN_SPAN
14 SENSOR_UNIT
15 TRIMMED_VALUE
16 SENSOR_TYPE
18 SENSOR_SERIAL_NUMMER
19 PRIMARY_VALUE
182
LOI
DTM name
(1)
location
Static Revision
N/A
No.
Tag N/A
Strategy N/A
Alert Key N/A
Target Mode N/A
Actual Mode N/A
N/A N/A
Pressure raw
N/A
value
Upper Sensor
N/A
Limit
Lower Sensor
N/A
Limit
Upper
CALIB->
Calibration
UPPER
Point
Lower
CALIB->
Calibration
LOWER
Point
Calibration
N/A
Min Span
Sensor Unit UNITS
Pressure
Trimmed UNITS
Value
Sensor Type N/A
Sensor Serial
N/A
Number
Primary Value N/A
Reference Manual
00809-0100-4797, Rev DA
Definition
The revision level of the static data
associated with block; the revision value
will be incremented each time a static
parameter value in the block is changed.
The user description of the intended block
application.
Grouping of function blocks.
The identification number of the plant unit.
This information may be used in the host
for sorting alarms, etc.
Contains desired mode of the block
normally set by the operator or a control
specification.
Contains the actual, permitted, and normal
modes of the block.
Contains the current states of the block
alarms
Raw sensor value, untrimmed, in
SENSOR_UNIT
Upper sensor range value, in SENSOR_UNIT
Lower sensor range value, in SENSOR_UNIT
The value of the sensor measurement used
for the high calibration point. Unit is
derived from SENSOR_UNIT
The value of the sensor measurement used
for the low calibration point. Unit is derived
from SENSOR_UNIT
The minimum span that is allowed
between the calibration high and low
points.
Engineering units for the calibration values
Contains the sensor value after the trim
processing. Unit is derived from
SENSOR_UNIT
Sensor type (capacitance, strain gauge)
Sensor serial number
Measured value and status available to the
Function Block. The unit of
PRIMARY_VALUE is the
PRIMARY_VALUE_UNIT.
®
PROFIBUS Block Information