Panaboard Operation Panel - Panasonic Panaboard UB-7325 Operating Instructions Manual

Computer Interfacing

■ Panaboard Operation Panel

It is possible to perform the same operations as with the electronic board control panel (page 9) from the following
Panaboard Operation buttons.
Note
• While the Panaboard Operation Panel is displayed, the Copy Key on the electronic board control panel is
used for scanning images into the computer.
Panel
Contrast/
Remaining Film
Indicator
Contrast Button
Scan Button
Multi-Copy/
Error Indicator
Multi-Copy/Stop
Button
Advance Button
Reverse Button
22
Name
This lamp indicator notifies the user when the time to replace the
thermal transfer film is approaching (estimated) and of the contrast used
during scanning or copying.
Indicator off:
Indicator on:
Indicator flashing*:
* The flashing indicator will go out after the power is turned off, or
the printer has been opened and closed. (When copying is per-
formed, this indicator will begin flashing again.)
Each time this button is pressed, the unit will alternate between normal
and dark contrast modes (Normal/Dark).
This button scans the screen.
This indicator displays the number of copies to be made. The display
changes each time the Multi-Copy/Stop Button is pressed.
Example: 1 → 2 → ··· → 9 →
(Selecting "
When an error occurs, a flashing symbol will appear in this display to
indicate the error status. (See page 27.)
When making multiple copies or copying 4 screens continuously, press
this button until the desired number of copies or "
Multi-Copy/Error Indicator. This button can also be pressed to stop
copying while executing multiple copies or copying 4 screens
continuously.
• The display changes as shown below each time the screen is copied.
After reaching 0, the display will reset to 1.
Example for multiple copies:
5 → 4 → 3 → 2 → 1 → 0 → 1 (Number is counted down.)
Example for copying 4 screens continuously:
* If scanning, the setting 1 to 9 for the number of copies or "
copying 4 screens continuously is ignored.
Clicking this button advances the screen from right to left.
Clicking this button twice advances two screens from right to left.
Clicking this button advances the screen from left to right.
Clicking this button twice advances two screens from left to right.
Description
Normal scanning or copying contrast
Darker than normal scanning or copying contrast
Almost time to replace the thermal transfer film
(Note that only about 15 more sheets may be
copied when this indicator starts flashing.)
Replacement film (UG-6001) is separately
available from the dealer where you purchased
your unit.
" allows you to copy 4 screens continuously.)
→ → → → 0 → 1 (Display changes.)
→ 1 → ···
" is displayed on the
" for