Intended Use; Improper Use; Residual Risk; Additional Safety Rules - Panasonic EYFPA1C Operating Instructions Manual

Original instructions: English
Translation of the original instructions:
Other languages
I

. INTENDED USE

This tool is a Cordless Impact Wrench and can
be used to tighten bolts, nuts, and screws. Ad-
ditionally, it provides a torque control function
that automatically stops tool operation when
a preset load is reached to deliver consistent
tightening torque.

IMPROPER USE

The use of the tool other than INTENDED USE
is dangerous and must be avoided.
The tool must not be used for the purposes
such as the following;
• to mix paint or building materials,
• polishing, grinding, sharpening, engraving.

RESIDUAL RISK

Some residual risks remains even with proper
use of the tool such as the following;
• contact with the rotating bit
• contact with the sharp edges of material or
something.
Read "the Safety Instructions" booklet
and the following before using.
II
. ADDITIONAL SAFETY
RULES
1) If the bit becomes jammed, immediate-
ly turn the trigger switch off to prevent
an overload, which can damage the bat-
tery pack or motor. Use reverse motion to
loosen jammed bits.
) Do NOT operate the Forward/Reverse
lever when the trigger switch is on. The
battery will discharge rapidly and damage
to the unit may occur.
3) During charging, the charger may become
slightly warm. This is normal. Do NOT
charge the battery for a long period.
4) Do not strain the tool by holding the speed
control trigger halfway (speed control
mode) so that the motor stops.
5) To prevent injury during use, hold the tool
steady at all times and avoid waving it
around.
6) Make certain that there are no hidden
gas or water pipes, or electrical wires in
the area where you will be working. Com-
ing into contact with hidden pipes or wires
could result in electric shock, or water or
gas leaks.
7) Make sure to hold the object you are
working on steady.
8) Check for damaged parts.
• Check thoroughly for damage to the
protective cover and other parts before
operating.
• Check to make sure the tool and all of
its functions are working properly.
• Check the adjustment of all movable
parts, and check all fixed parts to make
sure they are fitted properly and free of
damage. Check all parts of the tool for
abnormal function.
9) When attempting to repair the protec-
tive cover or other parts, please follow the
instructions in the user manual. In cases
where there are no instructions in the
manual, please take it back to the store to
have it repaired.
10) If the tool gets exceptionally hot dur-
ing use, please take it in for service and
repair.
11) To avoid potential injury, keep face and
hands away from the drill bit and any
shavings.
1) Do not wear gloves when operating the
tool, as they may get caught by the drill,
leading to injury.
13) Battery terminals, screw shavings, and
tool accessories such as drill bits will be
very hot immediately after operation. Do
not touch them as there is a risk of burn-
ing yourself.
- 9 -
EN