Important Safety Instructions - Bosch NGM5455UC Installation Manual

9 IMPORTANT SAFETY INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS
BOSCH COOKTOP CONVERSION KIT FOR
TRADITIONAL MODELS NATURAL GAS (NG) TO
PROPANE (LP) GAS
This kit is used to convert only NGM sealed burner
cooktops from natural gas operation to propane gas
operation. This kit cannot be used to convert other Bosch
model sealed burner cooktops, ranges, or any other brand
of cooktops.
WARNING
This conversion kit shall be installed by a qualified
service agency in accordance with the manufacturer's
instructions and all applicable codes and requirements
of the authority having jurisdiction. If the information in
these instructions is not followed exactly, a fire,
explosion or production of carbon monoxide may result
causing property damage, personal injury or loss of life.
The qualified service agency is responsible for the
proper installation of this kit. The installation is not
proper and complete until the operation of the converted
appliance is checked as specified in the manufacturer's
instructions supplied with the kit.
IMPORTANT: Only a qualified service technician or
installer should make this conversion
INSTALLER: Please leave these Conversion Instructions
with this unit for the owner.
OWNER: Please retain these instructions for future
reference.
For Massachusetts Installations:
1. Installation must be performed by a qualified or
licensed contractor, plumber, or gas fitter qualified or
licensed by the state, province or region.
2. Shut-off valve must be a "T" handle gas cock.
3. Flexible gas connector must not be longer than 36
inches.
English 2
CAUTION
When connecting the unit to the propane gas, make
certain the propane gas tank is equipped with its own
high pressure regulator. In addition, a pressure
regulator was supplied with the cooktop. This second
regulator must be installed with the cooktop. The
maximum gas pressure to this appliance is not to
exceed 14.0 inches water column from the propane gas
tank regulator.
The following must be met when testing supply piping
system:
a) The appliance and its individual shut-off valve must
be disconnected from the gas supply piping system at
test pressures in excess of 1/2 psig (3.5 kPa).
b) The appliance must be isolated from the gas supply
piping system by closing its individual manual shut-off
valve during any pressure testing of the gas supply
piping system at test pressures equal to or less than 1/2
psig (3.5 kPa).
9001070927 Rev A