Step 2 - Replace The Orifices - Bosch NGM5455UC Installation Manual

Natural
Gas
Important - Attach the metallic sticker (included with this
conversion kit) to the bottom of the appliance as shown,
placing it near the appliance data plate (shows model
number and information about the appliance). This sticker
provides notice that the appliance has been converted for
use with LP gas.
.
bottom of cooktop

Step 2 - Replace the Orifices

1. Remove the grates and burner caps.
Note: Do not remove the ignitor from the unit.
2. Remove the orifices.
Note: The orifices require a 7 mm socket driver for
removal/replacement. The driver will need to be
inserted approximately 2 1/2" (64 mm) into the
burner cavity to reach the orifice.
Hint: To reduce the chance of the orifice being dropped
from the socket driver, add a piece of foam tape or
adhesive tape inside the socket.
a) Trim a small piece of the foam tape provided with
this kit (about 1/4" x 1/2"; 6mm x 12mm).
b) Fit this so the tape wraps against one side of the
socket so it stays in place.
c) When pressing the socket driver onto the orifice,
the tape will fit to the orifice and help prevent the
orifice from falling out of the socket during
extraction.
9001070927 Rev A
Save the NG orifices in case there is need later to restore
the appliance to use natural gas again.
LP
Gas
4. Identify the correct placement of the LP gas orifices as
layed out on the orifice package card.
The orifice sizes are shown in the white circles
corresponding to each burner as shown in the image
below. These numbers are engraved on the top of each
orifice. It is very important to install the correct orifice
size for each burner.
5. Insert each of the LP gas orifices provided with this kit
into the socket (using the small piece of foam tape to
assure a tight fit).
a) Check to be sure the small piece of foam tape used
b) When pressing the socket driver onto the orifice,
This will help prevent the orifice from falling out of the
socket during insertion.
earlier is fitted to wrap against one side of the
socket.
the tape will help the orifice fit more snugly inside
the socket. This will help prevent the orifice from
falling out of the socket during insertion.
English 5