Installation - Broan LP80 Installation Manual

Page 3

Installation

Tools needed
• Power screwdriver with a Phillips bit
• Phillips screwdriver
• Wire insulation stripper
• Wire cutter
1
Remove from Packaging
Materials needed
• 4" round metal ducting recommended for best performance.
Use of other ducting is acceptable but may impact performance.
• Roof cap or wall cap (built-in damper recommended)
• Tape to seal duct connections
• Drywall screws, sheet metal screws or wire
• Electrical wiring and supplies per local code requirements
LP80 Installation Guide
n
Punch out Mask
from packaging.
See Step 5.