Samsung RF263BEAE SERIES User Manual page 13

1. Pull out the freezer drawer
see the lower hinge
2. Insert a philips screwdriver (+)
of the lower hinge.
4
3. Adjust the height by turning a philips
screwdriver (+)
counterclockwise (
1
When you turn a philips screwdriver (+)
counterclockwise (
move up.
INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a fi lter is one of the helpful
features on your new refrigerator. To help promote
better health, the water fi lter removes unwanted
particles from your water. However, it does not
sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that.
In order for the ice maker to operate properly, a
water pressure of 138~862 kPa is required.
Under normal conditions, a 0.17 L cup can be
fi lled in about 10 seconds.
If the refrigerator is installed in an area with low
water pressure, you can install a booster pump to
compensate for the low pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator is
properly fi lled. To do this, press the water dispenser
lever until the water runs from the water outlet.
DA68-02615A(0.0).indb 13
,then you can
1
.
2
into the shaft
3
clockwise ( ) or
DOWN
3
).
UP
2
4
3 3
), the door will
UP
Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper tubing
and compression nut.
Connecting to the water supply line
1. First, shut off the main water
supply.
2. Locate the nearest cold water drinking line and
install the pipe clamp and shut off valve.
Cold water line
Pipe clamp
Shut off valve
3.
Connect the water line installation kit to the
shut off valve.
Cold water line
Pipe clamp
Shut off valve
Connecting the water supply line to
the refrigerator.
There are several items that you need to purchase
to complete this connection.
You may fi nd these items sold as a kit at your local
hardware store.
Use Copper Tubing Use Plastic Tubing
• copper tubing •
• compression nut (1pc)
• Ferrule (2pc) •
Water line installation kit
plastic tubing
→ Molded end(Bulb)
compression nut (1pc)
setting up _13
2012.7.11 8:41:19 PM