Tools Required - Craftsman 917.20403 Operator's Manual

Mower
Lift Link ___
(5) 1-3/16 Assemblies
O.D. Washers
(1) Small
Retainer Springs
(5) Large
Retainer Springs
(1) Front \_
Lift Link _
Assembly
if Equipped
(1) Anti=Sway Bar
©
(1) 3/4 o.o.
Washers
(1) Small Retainer
Springs
Mower Front Wheel
(1) Shoulder Bolt
(1) Wheel
©
(1) 1-1/4 o.o.
Washer
(1) 3/8=16
Locknut
Quick Connect
3
Slope Sheet
*installed by Dealer
*Brush Guard Kit
Battery
(2) Hex Bolts
(2) Nut Keps
Your new tractor has been assembled at the factory with exception of those parts left
unassembled for shipping purposes. To ensure safe and proper operation of your tractor
all parts and hardware you assemble must be tightened securely. Use the correct tools
as necessary to ensure proper tightness.
TOOLS REQUIRED
FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(2) 7/16" wrenches Utility knife
(1) 1/2" wrench Tire pressure gauge
(1) 3/4" wrench Pliers
(1) 3/4" socket w/drive ratchet
(1) 9/16" wrench Flashlight
When right or left hand is mentioned in this
manual, it meanswhenyou areintheoperating
position (seated behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
• Remove all accessible loose parts and
parts cartons from carton.
• Cut along dotted lines on all four pan-
els of carton. Remove end panels and
lay side panels flat.
• Remove mower and packing materials.
• Check for any additional loose parts or
cartons and remove.
7