Table of Contents
Advertisement
Once the system is enabled, it is possible to set the
current speed as the desired speed by pressing RES
(6) or SET (7): press RES (6) if no target speed has
been previously set.
In this case, the system saves the vehicle current
speed and keeps it without the rider having to work
on the twistgrip: the set speed is displayed on the
instrument panel.
In stand-by mode, if you press RES (6) and a target
speed has been previously set and the operating
conditions are met, the system starts working again
and brings the vehicle to the last set target speed.
It is possible to enable the Ducati Cruise Control only
if the below conditions are met:
-
second gear or higher engaged;
-
vehicle speed higher than or equal to 50 Km/h (30
mph) or lower than or equal to 200 Km/h (125
mph);
-
the brake has been applied at least once (no
matter if at the front or the rear side) after the
key-ON.
The Ducati Cruise Control can be disabled as follows:
-
turning the throttle twistgrip in the direction as to
decelerate;
-
pressing button (5);
-
activating the front brake;
-
activating the rear brake;
-
pulling the clutch.
The Ducati Cruise Control system controls the vehicle
speed only between 50 Km/h (30 mph) and 200 Km/
h (125 mph).
149
Advertisement
Table of Contents
