Operation Status - Outback Power Systems MX60 Installation And User Manual

The MX60 Charge Controller has a 4 line, 80 character LCD display and four "soft key" buttons to allow the user to
adjust battery charging parameters and access other information. The MX60 has an adjustment screen lockout that
requires an access code to make any changes.
The MX60 is factory preconfigured for a 12V battery system. All of the default settings are multiples of 12V nominal
settings. The default bulk setting is for 14.3 VDC. The float setting is 13.15 VDC. The controller will process up to 60
amps of output current. It is recommended to install up to a maximum of 48 amps of PV to give the controller some room
to boost the PV current.
Figure 5 MX60 Start-up Screen. Note that the selected nominal battery system
Figure 6 shows the Main Status Screen. This default screen shows the following information:
Top Line
Second Line
Third Line
Fourth Line
Software Version Check: Hold button No.2 down to show the software version.

Operation Status

OutBack
Power
MX60
1
2
Soft keys
voltage is shown in the upper right corner.
PV array voltage
Current in from PV array
Instantaneous output watts Aux relay status
Daily KWH produced
PV 50
In 20
Watts 1000
KWH 02.5
Figure 6 MX60 Main Status Screen
24V
Systems
4
3
Battery system voltage
Current out to battery system
Mode of operation
Bat 25 Vdc
Out 40 Amps
Aux off
MPPT
7