Installation - Outback Power Systems MX60 Installation And User Manual
Pv mppt charge controller
Hide thumbs
Also See for MX60:
- Installation, programming, and user's manual (92 pages) ,
- Quick manual (12 pages)
Table of Contents
Advertisement
Installation
The MX60 is designed to be mounted in a variety of ways. One of the more common methods of mounting is on an
OutBack charge controller bracket (CCB), attached to an OutBack PSDC enclosure. Each MX60 comes with three #10
stainless steel sheet metal screws for this purpose. Under the wiring compartment cover are holes through the mounting
feet for attachment to the CCB . There is also a mounting tab at the top of the MX60. When mounted to the OutBack
CCB the left side knockout will line up with knockouts in the PSDC. A standard ¾" or 1" plastic snap-in bushing will offer
protection from chafing between the two boxes. Note that there are two placement options on the CCB that can be used
to match with knockouts in the PSDC. Mounting holes and knockouts are compatible with C40 controllers to help set an
industry standard. Two MX60 controllers may be installed on the CCB. Note the placement shown in Figure 1.
Figure 1 Two MX60 Charge Controllers mounted on a CCB
3
Hide quick links:
Advertisement
Table of Contents
