Adding/Removing Laundry; Changing The Programme; Cancel The Programme; Programme End During Rinse Hold - Siemens WM..U... Instruction And Installation Manual

Notes
To remove the laundry at the end of
■
the programme,deactivate the
childlock.
The childlock remains active, even
■
once the appliance has been
switched off.
If the appliance is switched off while
■
the programme is running and
childlock is activated, the
programme continues when the
appliance is switched back on.

Adding/removing laundry

After starting the programme, you can
add or remove laundry if necessary.
Touch the I button. The appliance
checks whether reloading is possible.
If the following appears on the Touch-
Display:
The symbol Πdisappears, reloading
■
is possible.
The symbol Πlights up, reloading is
■
not possible.
To continue the programme, touch the
I button. The programme continues
automatically.
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.

Changing the programme

If you have started the wrong
programme by mistake, you can
change the programme as follows:
Touch the I button.
1.
Select another programme.
2.
And touch the I button again. The
3.
new programme starts from the
beginning.
Operating the appliance

Cancel the programme

For programmes at high temperatures:
Touch the I button.
1.
To cool down laundry: Select
2.
q Rinse/Spin 0.
And touch the I button again.
3.
For programmes at low temperatures:
Touch the I button.
1.
Select q Rinse/Spin 0.
2.
And touch the I button again.
3.
Programme end during rinse
hold
The I button flashes on the Touch-
Display, and the preset spin speed and
remaining programme length are
displayed for the selected programme.
Continue the programme by:
Touch the I button or
■
Change the spin speed (if
■
necessary) and then touch the I
button again.
If the water only needs to be
Note:
drained, touch the I button approx.
1 minute after the programme starts,
before the spin cycle begins. Then
switch the appliance off. The
programme is interrupted and the
door lock is released. The laundry
can be removed.

Programme end

End lights up on the Touch-Display and
I and Πdiaplays are off.
en
19