Programme Default Settings; Temperature; Spin Speed; Finish In - Siemens WM..U... Instruction And Installation Manual

0
Programme default
settings
You can change the default settings for
P r o g r a m m e d e f a u l t s e t t i n g s
selected programmes. The settings can
be changed even while the selected
programme is running. The effects
depending on the progress of the
programme.

Temperature

(°C)
Depending on what stage the
programme is in, you can change the
temperature before and during the
programme.
The maximum temperature that can be
set depends on the programme that has
been selected.

Spin speed

(0)
Depending on what stage the
programme is in, you can change the
spin speed (in rpm; revolutions per
minute) before and during the
programme.
setting $: "Rinse hold" = no final spin.
The laundry stays in the water after the
final rinse.
You can select "Rinse hold" to prevent
creasing if the laundry will not be taken
out of the appliance immediately after
the programme has ended.
To continue/end the programme
~ Page 19
The maximum speed that can be set
depending on the model and the
programme that has been selected.

Programme default settings

Finish in

(f)
After selecting a programme, the
programme duration is displayed, e.g.
1:51 (in h:min (hours:minutes)).
Before the programme starts, you can
move the time at which the programme
should be finished backwards, in
increments of 30 minutes and up to a
maximum of 24 h (h=hour).
To do this:
Select a programme (except
1.
» MyTime programme).
The programme duration is
displayed for the selected
programme, e.g. 2:30
(hours:minutes).
Touch the + button repeatedly until
2.
the required number of hours is
displayed.
The setting values are
Note:
increased using the + button, and
decreased using the - button.
Touch the I button.
3.
After the programme starts, the
selected time, e.g. 8 h is displayed and
counted down until the washing
programme starts. The duration of the
programme is then displayed.
The length of the programme is
Note:
automatically adjusted when the
programme is running. Changes to the
default programme settings or
programme additional settings may also
change the programme duration.
en
13