Avital 2101L Installation Manual page 6

H H 1 1 / / 4 4 B B L L A A C C K K / / W W H H I I T T E E D D o o m m e e l l i i g g h h t t S S u u p p e e r r v v i i s s i i o o n n O O u u t t p p u u t t
Connect this wire directly to the domelight circuit in the
vehicle. The on-board relay will drive circuits up to 30
amperes. The polarity of this output is determined by
the connection of the input wire H1/3 in the Relay
Harness.
N N o o t t e e : If the input wire H1/3 is not connected, there will
be no output on this wire.
H H 1 1 / / 5 5 G G R R E E E E N N / / B B L L A A C C K K L L o o c c k k # # 3 3 0 0 C C o o m m m m o o n n ( ( O O u u t t p p u u t t ) )
The system has door lock relays on-board, and can
directly interface with most electric power door lock
systems drawing 30 amps or less. It can also drive
aftermarket actuators directly. (Some vehicles require
that an aftermarket actuator be added to the driver's
door to allow system control, see Type D wiring section
in Tech Tip Document 1041).
H H 1 1 / / 6 6 W W H H I I T T E E / / B B L L A A C C K K L L o o c c k k # # 8 8 7 7 A A N N o o r r m m a a l l l l y y C C l l o o s s e e d d
See H1/5.
H H 1 1 / / 7 7 V V I I O O L L E E T T / / B B L L A A C C K K L L o o c c k k # # 8 8 7 7 N N o o r r m m a a l l l l y y O O p p e e n n e e d d
( ( I I n n p p u u t t ) )
See H1/5.
6
© 2009 Directed Electronics, inc.