Avital 2101L Installation Manual page 11

H H 1 1 / / 1 1 8 8 R R e e d d / / w w h h i i t t e e c c h h a a n n n n e e l l 2 2 , , 2 2 0 0 0 0 m m A A ( ( - - ) ) o o u u t t p p u u t t
When the system receives the transmitter code control-
ling Channel 2 for longer than 1.5 seconds, the
red/white wire will supply an output as long as the trans-
mission continues. This is often used to operate a
trunk/hatch release or other relay-driven functions.
I I m m p p o o r r t t a a n n t t
Never use this wire to drive anything but a
! !
relay or a low-current input! The transistorized output
can only supply 200 mA of current. Connecting directly
to a solenoid, motor, or other high-current device will
cause it to fail.
H1/18 RED/WHITE
11
© 2009 Directed Electronics, inc.