Solving Problems; Checking The Printer Status; Checking Messages On The Lcd Screen - Epson XP-900 Series User Manual

User's Guide

Solving Problems

Checking the Printer Status

Checking Messages on the LCD Screen

If an error message is displayed on the LCD screen, follow the on-screen instructions or the solutions below to
solve the problem.
Error Messages
Printer error. Turn the power off and on again.
For details, see documentation.
Operation canceled. An error occurred while
saving.
Ink is low.
You need to replace the following ink
cartridge(s).
Paper Configuration is disabled. Some features
may not be available. For details, see your
documentation.
The printer's ink pad is nearing the end of its
service life. Please contact Epson Support.
The printer's ink pad is at the end of its service
life. Please contact Epson Support.
Communication error. Check if a computer is
connected.
Combination of the IP address and the subnet
mask is invalid. See your documentation.
Update the root certificate to use cloud services.
Solving Problems
Solutions
If the error message is still displayed after turning the power off and on
again, contact Epson support.
The external storage device, such as a memory card, may be damaged.
Check if the device is available.
You can continue printing until you are prompted to replace the ink
cartridges. However, note that the printer cannot print if any of the ink
cartridges is expended. Prepare new cartridges as soon as possible.
To ensure you receive premium print quality and to help protect your
print head, a variable ink safety reserve remains in the cartridge when
your printer indicates it is time to replace the cartridge. Replace the
cartridge when you are prompted to do so.
If Paper Configuration is disabled, you cannot use AirPrint. In addition,
messages notifying you that the paper size and type do not match are
not displayed. Keep this setting enabled unless you always use the same
size and type of paper and do not need to change the paper settings.
Contact Epson or an authorised Epson service provider to replace the
ink pad*. It is not a user-serviceable part. The message will be displayed
until the ink pad is replaced.
x
Press the button to resume printing.
Contact Epson or an authorised Epson service provider to replace the
ink pad*. It is not a user-serviceable part.
Connect the computer and the printer correctly. If you are connecting
over a network, see the page that describes the network connection
method from the computer.
If the error message is displayed during scanning, make sure that Epson
Scan 2 and Epson Event Manager are installed on the computer.
Enter the correct IP address or default gateway. Contact the person who
setup the network for assistance.
Run Web Config, and then update the root certificate.
156