Installing Additional Memory; Ddr4-Sdram Sodimms - HP 260 G2 DM Hardware Reference Manual

Installing additional memory

The computer comes with at least one preinstalled double data rate 4 synchronous dynamic random access
memory (DDR4-SDRAM) small outline dual inline memory module (SODIMM). There are two memory sockets
on the system board that can be populated with up to 32 GB of memory.

DDR4-SDRAM SODIMMs

For proper system operation, the SODIMMs must be:
industry-standard 288-pin
●
unbuffered non-ECC PC4-17000 DDR4-2133 MT/s-compliant
●
1.2 volt DDR4-SDRAM SODIMMs
●
The SODIMMs must also:
support CAS latency 15 DDR4 2133 MT/s (15-15-15 timing)
●
contain the mandatory Joint Electronic Device Engineering Council (JEDEC) specification
●
In addition, the computer supports:
512-Mbit, 1-Gbit, 2-Gbit, 4-Gbit, and 8-Gbit non-ECC memory technologies
●
single-sided and double-sided SODIMMs
●
NOTE: The system will not operate properly if you install unsupported SODIMMs.
12 Chapter 2 Hardware upgrades