Outline Of Cooling Operation - Mitsubishi Electric SRK19CIS Technical Manual

4.7 Outline of cooling operation

(1) Operation of major functional components
Functional
components
Indoor fan motor
Flap and louver
Display
Outdoor fan motor
Electric expansion valve
(2) Fan speed switching
Fan speed switching
Flow control
Air scroll
Swing flap or louver
Swing stop
(a) Auto fan control
The indoor fan is automatically controlled in accordance with the difference between the room temperature (detected by the
room temperature sensor) and the termostat setting as shown below.
(3) Thermostat operation
The compressor and outdoor fan and turned on and off as shown below according to the temperature setting.
(4) HIGH POWER operation ( "HI POWER" button on the remote control : ON)
The following operation is performed for 15 minutes without relation to the set temperature or fan speed setting.
Indoor unit fan
Outdoor unit fan
Compressor
(5) ECONOMY operation ( "ECONO" button on the remote control : ON)
The set temperature changes as shown at right, and the
indoor unit fan speed is set on speed 4.
Item
When the compressor
command is OFF
ON
ON or OFF
Lights up
Depending on the stop mode
AUTO
Auto fan control
Speed 4
+1
Thermostat setting point
Compressor
OFF
Outdoor fan
Speed 9 fixed
ON
ON
When the compressor
command is ON
ON
ON or OFF
Lights up
ON
Depending on the EEV control
HIGH
Speed 8
Speed 8
Speed 8
Speed 8
Speed 6
+2 +3
ON
-1
Room temp.
Set temp.
Notes (1) Room temperature is not adjusted during the HIGH POWER operation.
(2) Protective functions will actuate with priority even during the HIGH POWER
operation.
Running time
Running start ~ 1 hour
1~2 hours
2 hours ~
16
- -
When the compressor goes
OFF due to an anomalous stop.
OFF
Stop position control
Lights up or flashes
Depending on the stop mode
MED
Speed 6
Speed 6
Speed 6
+4
Set temperature compensation
Set temperature +0.5
Set temperature +1.0
Set temperature +1.5
LOW
Speed 4
Speed 4
Speed 4