Configuration Examples; Lacp Mad-Enabled Irf Configuration Example - H3C S5120-EI Series Configuration Manual

Task
Display the load sharing mode for
IRF links.
Display the master/subordinate
switchover state of IRF members.
Display MAD configuration.

Configuration examples

This section provides IRF configuration examples for IRF fabrics that use different MAD mechanisms.

LACP MAD-enabled IRF configuration example

Network requirements
Set up a two-member IRF fabric at the access layer of the enterprise network in
MAD in the IRF fabric, because the IRF fabric has a multi-chassis aggregate link to Device C, an H3C
device that supports extended LACP.
Figure 12 Network diagram
GE1/0/2
Device A
Configuration procedure
This example assumes that the system names of Device A, Device B and Device C are DeviceA, DeviceB,
and DeviceC respectively before the IRF fabric is formed.
Assign member IDs:
1.
# Keep the default member ID of Device A unchanged.
Command
display irf-port load-sharing mode
[ irf-port
[ member-id/port-number ] ] [ |
{ begin | exclude | include }
regular-expression ]
display switchover state [ slot
member-id ] [ | { begin | exclude |
include } regular-expression ]
display mad [ verbose ] [ | { begin
| exclude | include }
regular-expression ]
Device C
GE1/0/1 GE1/0/2
IRF
XGE1/1/2 XGE2/1/1
(IRF-port1/2) (IRF-port2/1)
IP network
GE2/0/1
Device B
26
Remarks
Available in any view
Available in any view
Available in any view
Figure 12. Configure LACP