Preparation For Starting - Hyundai DHY6000SE User Manual

Typical control panel layout for Single & Three phase machine.

3. PREPARATION for STARTING

Wear suitable PPE, suggested but not limited too
3.1. Selection and handling of fuel.
3.1.1. Selection of fuel.
3.1.1.1.
3.1.1.2.
3.1.1.3.
mixed in with the fuel. This can cause serious damage to the fuel injection pump
or the injector nozzle.
3.1.1.4.
expand in hot weather and overflow
3.1.1.5.
Typical control panel layout for Single phase machine.
•
DO NOT refill tank while engine is running or HOT.
• Do not smoke or allow flames or sparks in the area where the
engine is refueled or where the fuel is stored.
• Do not overfill the diesel tank and make sure the filler cap is
securely closed after refueling.
• Take care not to spill fuel when refueling. If any fuel is spilled,
make sure the area is clean and dry before starting the engine.
Only use standard specification diesel, this can be red or white.
Keep dust and water out of the fuel.
When filling the fuel tank from drums, make sure that no dust or water is
Do not overfill. Overfilling can potentially be very dangerous. Diesel can
Always leave a 25mm gap above the fuel level.
• Always check the engine oil level with the generator on a flat,
level surface before starting or refilling the machine.
Page 12 Rev 3