Remote Control; General Functions - ViewSonic CDX4952 User Manual

2.3.

Remote Control

2.3.1. General functions

1
2
3
4
5
6
7
8
9
10
11
12
[POWER] button
1
Press to switch on the display from standby mode.
Press again to turn it off and back into standby
mode.
[PLAY] button
2
Control playback of media files.
[ SOURCE] button
3
Press to toggle Video Source Menu. Press [ ] or
[ ] button to select one of the video sources among
Displayport, DVI-D, VGA, HDMI, Component, or
Video. Press [OK] button.
[MENU] button
4
Press to turn the OSD menu on/off.
[ ] button
5
• Press to move the selection up in OSD menu.
• Press to increase the value in OSD menu.
[ ] button
6
Press to move the selection left in OSD menu.
[OK] button
7
Press to activate the setting inside the OSD menu.
[ADJUST] button
8
Press to run the Auto Adjust function.
NOTE: This button is functional for VGA input only.
[ ] button
9
• Press to move the selection down in OSD menu.
• Press to decrease the value in OSD menu.
[ ] MUTE button
10
Press to turn the mute function on/off.
11
Select tasks or options.
20
[NUMERIC] buttons
12
Enter text for network setting.
Format button
13
Press to switch screen aspect ratio.
• For PC signal: FULL, NORMAL, CUSTOM, and
13
REAL.
• For Video signal: FULL, NORMAL, DYNAMIC,
14
CUSTOM, and REAL.
[EXIT] button
14
15
Press to turn back to the previous OSD menu.
[INFO] button
15
16
Press to turn on/off the information OSD displayed
on the upper right corner of the screen.
17
[ ] button
16
Press to move the selection right in OSD menu.
18
[OPTION] button
17
19
Access currently available options, picture and
sound menus.
[VOL UP] button
18
Press to increase the audio output level.
[VOL DOWN] button
19
Press to decrease the audio output level.
[ID SET] button
20 21
If a single large- screen matrix (video wall) is
created, set ID key to control each dispaly.
21
ID Remote Control:
You can set the remote control ID when you want to use
this remote control on one of several different displays.
Press [ID] button. The red LED blinks twice.
1. Press [ID SET] button for more than 1 second to
enter the ID ode. The red LED lights up.
Press the [ID SET] button again will exit the ID
Mode. The red LED lights off.
Press the digit number [0] ~ [9] to select the display
you want to control.
For example: press [0] and [1] for display No.1,
press [1] and [1] for display No. 11.
The numbers available are from [01] ~[255].
2. Not pressing any button within 10 seconds will exit
the ID Mode.
3. If an error pressing of buttons other than the digits
occurred, wait 1 second after the red LED lights
off and then lights up again, then press the correct
digits again.
4. Press [ID ENTER] button to confirm. The red LED
blinks twice and then lights off.
NOTE:
• Press [NORMAL] button. The green LED blinks
twice, indicating the display is in normal operation.
• It is ncecssary to set up the ID number for each
display before selecting its ID number.
8
COLOR buttons