Connections; Audio Out Terminals Connection - Panasonic TH-103PF10EK Operating Instructions Manual

Connections

AUDIO OUT Terminals connection

AC cord connection (see page 12)
– AC cord fi xing
Plug the AC cord into the display unit.
Plug the AC cord until it clicks.
Fix the AC cord with the clamper.
Note:
Make sure that the AC cord is locked on both the
left and right sides.
– Cable fi xing bands Secure any excess cables with bands as required.
Pass the attached cable
fi xing band through the clip
as shown in the fi gure.
1
SLOT1
Optional Terminal DVI-D IN Terminals
(equivalent of DVI-D
Board Insert Slot
Terminal Board for PF
(covered)
Series (TY-FB9FDD))
(see page 11)
Note: At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.
8
Close
Open
To secure cables connected to Terminals, wrap the cable fi xing band around them
then pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
To tighten:
Pull
2
AUDIO R AUDIO L
COMPONENT/RGB IN
DVI-D IN
SLOT2
COMPONENT/RGB IN and
Audio IN Terminals (equivalent
of BNC Component Video
Terminal Board (TY-42TM6A))
(see page 11)
R L
AUDIO OUT
Push until the
hook clicks.
2. Pull off.
1. Keep the knob
pressed.
To loosen:
Push the catch
P /C /R P /C /B Y/G
R R B B
SLOT3 PC IN
From EXTERNAL
monitor terminal
on Computer
(see page 9)
Stereophonic sound code
audio equipment
line-in
Unplug the AC cord
Unplug the AC
cord pressing
the two knobs.
Note:
When disconnecting the AC
cord, be absolutely sure to
disconnect the AC cord plug
at the socket outlet fi rst.
Pull
R
AUDIO
SERIAL AUDIO OUT
From SERIAL From input
Terminal on on audio
Computer amplifi er
(see page 10) (see page 8)
L