Initial Selections; Selecting The Input Signal; Selecting The On-Screen Menu Language - Panasonic TH-103PF10EK Operating Instructions Manual

Initial selections

Selecting the input signal

Select the input signals to be connected by installing the optional Terminal Boards.
Notes:
• Selecting is also possible by pressing the INPUT button on the unit.
• Input terminal will not be selected if the terminal board is not installed
into the SLOT.
• Select to match the signals from the source connected to the component/
RGB input terminals. (see page 39)
• In 2 screen display, the same input mode cannot be selected for the main
picture and sub picture.
• Image retention (image lag) may occur on the plasma display panel when
a still picture is kept on the panel for an extended period. The function that
darkens the screen slightly is activated to prevent image retention (see
page 50), but this function is not the perfect solution to image retention.

Selecting the On-Screen Menu Language

Press to select the input signal to be played back from the
equipment which has been connected to the Plasma Display.
Input signals will change as follows:
INPUT1
Press the INPUT "1", "2", "3" or "PC" input mode selection button to
select the input mode.
This button is used to switch directly to INPUT mode.
These buttons can only display the slot which is installed. If you
press the button whose slot is not installed, it automatically displays
the current input signal.
When a dual input terminal board is attached, A or B is displayed
depending on the selected input signal. (Ex. INPUT1A, INPUT1B)
Press to display the Setup menu.
Press to select the OSD Language.
Press to select your preferred language.
Selectable languages
English(UK)
Deutsch
Français
Italiano
INPUT2 INPUT3
Español
ENGLISH(US)
.......(Chinese)
.......(Japanese)
PC
Setup
Signal
Component/RGB-in select
Input label
Power save
Standby save
Power management
Auto power off
OSD Language
ENTER/
+
/
VOL
-
/
MENU
INPUT
1/2
RGB
PC
Off
Off
Off
Off
English ( UK )
13