Table of Contents
Advertisement
M570 series oscilloscope with rollmode
Software License Agreement
This legal document is an agreement between you, the end user, and ETC
s.r.o. By installing this product on your computer, you are agreeing to become bound
by the terms of this agreement and warranty conditions.
1. GRANT OF LICENSE. ETC s.r.o. as Licensor, grants you, the Licensee, a
nonexclusive right to use and display this copy of the M570 roll-mode software
(hereinafter the "SOFTWARE"), this EM570 device and accompanying written
materials, on a single COMPUTER at a single location and only together so long as
you comply with the terms of this License.
2. OWNERSHIP. As the LICENSEE, you own the magnetic or other physical
media on which the SOFTWARE is originally or subsequently recorded or fixed, but
an express condition of this License is that ETC s.r.o. retains title and ownership of
the SOFTWARE recorded on the original disk copy(ies) and all subsequent copies of
the software, regardless of the form or media in or on which the original and other
copies may exist. This License is not a sale of the original SOFTWARE or any copy.
3. COPY RESTRICTIONS. This SOFTWARE, EM570 device and
accompanying written materials are copyrighted. Unauthorized copying or copy
attempt of the EM570 device, including module which has been modified or included
with any other system, or of written materials is expressly forbidden. It is, however,
allowed to pass SOFTWARE on as the DEMO version. You may be held legally
responsible for any copyright infringement which is caused or encouraged by your
failure to abide by the terms of this License.
4. DISCLAIMER OF THE WARRANTY OF ANY KIND CONCERNING
SOFTWARE. This SOFTWARE and accompanying written materials are provided
"AS IS" without a warranty of any kind. Further, ETC s.r.o. does not warrant,
guarantee or make any representations regarding the use, or the results of use, of the
SOFTWARE, EM570 device or written materials in terms of correctness, accuracy,
reliability, currentness, or otherwise. The entire risk as to the results and performance
of the software is assumed by you.
Precautions
Please follow these recommendations to avoid any possible problems that
might occur while using the oscilloscope:
- read the User's Guide
- always connect device using cable, which is the part of package. If it is not possible,
always use USB 2.0 cable.
- never connect signal with absolute voltage higher than 200V to measuring inputs.
This value is valid for frequencies lower than 100kHz. Over this frequency, the
voltage lowers with raising frequency. For example frequency 200kHz of 100V,
400kHz of 50V is the limit.
- never connect voltage lower than –10V and higher than +13V to the external
triggering input (frequency lower than 20kHz). Over 20kHz, voltage lower than -0.5V
or higher than +4V is not recommended.
- never connect voltage to the oscilloscope ground, it may result in device or computer
damage
- never disassemble device, since there are no user serviceable parts inside
User's Guide
- 6 -
Advertisement
Table of Contents
