Waveform Display Mode Control; Fig. 4.5.1. - Data Save Controls; Fig. 4.6.1. - Waveform Display Mode Controls - ETC M570 series User Manual

M570 series oscilloscope with rollmode
The name of target file has to be inserted into the upper edit box.
The button opens standard operating system dialog, where you can select
target file.
Click „Save" to enter the "data saving" mode. The data are continuously saved
to disk during acquisition. The length of the file is indicated on the right of the "Size"
label.
"CLF" – (Clear file) erases the file
WARNING: The "Data save" controls are inactive, when the data acquisition is
in progress.
If the selected file already exists on the disk, measured data will be appended
to it.

4.6. Waveform display mode control

The controls are located in the bottom of the main window.
Fig. 4.6.1. – Waveform display mode controls
If more than 1 sample is displayed to one dot of the waveform, it is necessary
to set the mode of creating the dot. There are two buttons to choose the basic mode.
If "SNG" is selected, only the first sample of time period represented by the
dot is displayed.
If "Calc" is selected, the dot is calculated out of all samples. The method of
calculation depends on the following controls:
If the is activated, the displayed dot is calculated as average of the
measured samples.
If the is activated, the displayed dot is calculated as a maximum of
measured samples.
If the is activated, the displayed dot is calculated as a minimum of
measured samples.
Fig. 4.5.1. – Data save controls
User's Guide
- 14 -