Care And Maintenance; Cleaning The Air Filter - GE AIR 116 IN Service Manual & Installation Manual

10

Care and maintenance

Turn the power off and pull out the power plug before cleaning the air conditioner. Or
it may cause electric shock. Never dampen the air conditioner, it can cause the
electric shock. And never flush the air conditioner with water in any condition.
Volatile liquid like thinner or gasoline would damage the appearance of air conditioner
(only adopting soft dry cloth and wet cloth with neutral scour when cleaning air
conditioner appearance).
10.1
Clean the Front Panel
1 Take Down the Front Panel
Pull the grooves on both sides of panel at the same time with force in the direction as
shown by arrow, then take out the panel.
2 Clean the Front Panel
Use brush, water and neutral detergent to clean, then dry it in the shadow.
3 Install the Front Panel
Put the props on both ends of panel into fulcrum groove, then cover the panel cover
properly in the direction as shown by arrow
10.2 Cleaning the air filters
1 Take Down the air filter
Pull with force the front panel away an angle at the grooves of both ends of front panel in the
direction as shown by arrow, and then pull downward the filter to take it out as shown in the
diagram at the right.

2 Cleaning the air filter

To clear the dust adhering to the filters, you can either use a dust collector, or wash them with
warm water (the water with the neutral detergent below 45 Centidegree) when the filters are
very dirty (such as oil stain), and dry it in the shadow as shown in the diagram at the right.
3 Install the air filters
Install air filter properly in the direction as shown by arrow, let its side that marked
"Front" faces you, then cover and buckle the panel properly.
NOTE:
Don't dry the panel or air filter directly under sun burn; don't
wash them by hot water which is hotter than 45 degree
centigrade or burn it on fire (For these would cause
! ! ! ! !
Warning
28