Table of Contents
Advertisement
Changing Shooting Function Settings
If you set the mode dial to G, you can change the settings in the 4 tab
(p. 43).
Before attempting to shoot using a function explained in this section in
modes other than G, check if the function is available in those modes
(pp. 216 – 219).
Turning Off the AF Assist Beam
The lamp will automatically light to assist focusing in low light conditions when
you press the shutter button halfway. You can turn off the lamp.
Changing the Flash Timing
You can change the timing of the flash and shutter.
Choose [AF-assist Beam], then press the
qr buttons to choose [Off].
Choose [Flash Settings], then press the
m button.
Press the op buttons or turn the 7 dial
to choose [Shutter Sync.], then press the
qr buttons to choose a setting.
The flash fires right after the
1st-curtain
shutter opens.
The flash fires right before the
2nd-curtain
shutter closes.
183
Advertisement
Table of Contents
