Harman Kardon BDP 1/120 Service Manual page 12

harman/kardon
REAR-PANEL CONNECTIONS
Remote Infrared (IR) Input and Output: When the front-panel
Remote IR sensor is blocked, connect the IR Output of your receiver/
processor or an optional IR receiver to the Remote IR Input jack. The
Remote IR Output may be connected to the Remote IR Input of a
compatible product for remote control through the BDP 10. When
several devices are used, connect them in "daisy chain" fashion.
Composite Video Output:
or component video inputs, connect this video output to your A/ V
receiver/processor or directly to the display.
Component Video Outputs: If your A/ V receiver, surround processor
to the corresponding inputs on the receiver or TV. If your video display
has component input jacks marked "High Definition," use those jacks.
Analog Audio Outputs:
optical or coaxial digital audio connection, connect these jacks to the
A/V receiver or TV. Connect these jacks in addition to a digital audio
connection to make recordings for personal use, or for a multizone
system.
Coaxial and Optical Digital Audio Outputs: If your A/ V receiver
or surround processor is not capable of processing the audio from an
both) to the receiver/processor.
12
HDMI Output:
display device. If your A/ V receiver or surround processor is capable of
needed.
NOTE: If your A/V receiver or video display uses DVI connections,
separate audio connection. If your DVI-equipped display is not
HDCP-compliant, you must use an analog video connection.
Network Jack: Connect this standard RJ45 jack to a broadband
network (Ethernet) connection so that you may take full advantage
of BD-Live updates, features and enhancements of the BonusView
system. When the network connection is "live," the lights on either side
of the jack will flash to indicate network activity.
NOTE: When the BDP 10 is used with an IP-based or wireless
control device, connect a router/access point here, making certain
that one connection runs from the router to a broadband Internet
connection.
Master Power Switch: Flip on to apply power to the BDP 10,
placing it in the Standby mode. When the unit will not be used for an
extended period of time, or whenever it is necessary to remove the
unit from the AC power lines, flip the switch off.
AC Power Input: Connect the supplied AC power cord to this socket
first, and then to an unswitched AC outlet. Should the cord become
damaged, contact your authorized Harman Kardon dealer for a
replacement.
Fan Vents: This area contains vents used by the BDP 10's fan to cool
surface, to avoid overheating the unit.
12
BDP 1 / BDP 10 Service Manual
for BDP10