H3C S12500 Series Quick Start Manual page 14

Installing a card
This section describes how to install an MPU as an example.
To install an MPU:
Remove the protective box before installing an MPU:
1.
Put on an ESD-preventive wrist strap and then loosen the captive screws that fix the MPU to the
protective box with a Phillips screwdriver.
Pull the MPU out of the protective box gently, as shown in
Figure 15 Removing the protective box
Move the ejector levers on the front panel of the MPU outwards, hold up the MPU by one hand
2.
without touching any electronic components on the MPU, and hold the front panel by the other
hand to push the MPU into the slot along the slide rails slowly.
Push the ejector levers inward to ensure close contact between the MPU and the backplane.
3.
Position the screws into the holes and fasten them with a screwdriver to fix the MPU.
4.
Figure 16 Installing a card (for the S12504)
11
Figure 15.