Remote Operation; Operating From A Remote Location - Panasonic KX-FT901BX Operating Instructions Manual

Remote Operation

8.4 Operating from a remote location

You can call your unit from a remote location and access the answering device.
Important:
L Program the remote operation ID beforehand (feature #11, page 47).
L Set the unit to TAD/FAX mode before going out (page 35).
L Use a touch tone telephone for remote operations.
Helpful hints:
L When you press a key, press firmly.
L Please make a copy of the following table, and carry it with you when you go out.
1. Call your unit.
2. Enter the remote operation ID during the
TAD/FAX greeting message.
3. Enter a remote command within 10 seconds.
Key Remote command
Skips the greeting message
{0}
Repeats a message
{1}
Skips a message
{2}
New message playback
{4}
All message playback
{5}
8.4.1 Listening to recorded
messages
1
Call your unit.
2
Enter the remote operation ID during the
TAD/FAX greeting message.
3
When there are new recorded messages
1. A long beep will sound.
2. Short beep(s) will sound up to 8 times.
L This indicates the number of new
messages.
3. New messages will be played back.
When there are no new messages
1. A long beep will sound (short beep will
not sound).
2. Wait for 4 seconds or press {5}.
3. All recorded messages will be played
back.
When voice memory is full
6 beeps will sound after playing back the
messages. Erase unnecessary messages.
8. Answering Device (KX-FT907 only)
Answering device remote operation
{6}
{7}
{9}
{*}{4}
{*}{5}
{8}{0}
{8}{1}
{8}{2}
{8}{3}
{8}{4}
Room monitor
Re-records the greeting message
Stops re-recording of the greeting
message
Erases a specific message
Erases all messages
Changes to TEL mode
Turns ON message transfer
Turns OFF message transfer
Turns ON pager call
Turns OFF pager call
8.4.2 Remote operations using
remote commands
{1}: repeats a message. If you press this key
within 5 seconds of the beginning of a message,
the previous message will be played.
{2}: skips a message.
{4}: plays back new messages.
{5}: plays back all messages.
8.4.3 Other remote operations
To erase a specific message
Press {*}{4} while listening to the message you
want to erase.
L A long beep and 3 short beeps will sound.
The unit will then play back the next
message.
To erase all messages
Press {*}{5} to erase all messages.
L A long beep and 3 short beeps will sound.
43