Connections - Panasonic KX-FPC141 Operating Instructions Manual

Setup (Main Unit)

Connections

1
Connect the handset cord.
2 Connect the telephone line cord.
3
Connect the power cord.
The unit will automatically start to
detect the dialing mode of your
telephone line (see below).
When the power is turned on for the
first time, the unit will print some
basic information.
120 V, 60 Hz
(
Wall jack
(RJ11C)
Note:
For additional equipment protection, we recommend the use of a surge protector. The following types are
available; TELESPIKE BLOK MODEL TSB (TRIPPE MFG. CO.), SPIKE BLOK MODEL SK6-0 (TRIPPE
MFG. CO.), SUPER MAX (PANAMAX) or MP1 (ITW LINX).
The warranty does not cover damage due to power line surges or lightning.
When you operate this product, the power outlet should be near the product and easily accessible.
Automatic dialing mode setting
When the telephone line cord and the power cord are connected, the unit will automatically start to detect
the dialing mode of your telephone line.
Display:
CHECKING LINE
Wait until one of the following messages is displayed.
LINE IS TONE
LINE IS PULSE
If the power cord is disconnected or a power failure occurs, the unit will detect the dialing mode again when
power is restored.
If you connect the power cord before connecting the telephone line cord, the following messages will be
shown alternately.
NO TEL LINE
Connect the telephone line cord.
26
Power cord
Power surge )
protector
( Line surge )
Telephone
protector
line cord
Your line has touch tone service.
Your line has rotary pulse dial service.
INSERT TEL LINE